Aktuelle Veröffentlichungen
-
- Biermann, D.; Freiburg, D.; Stangier, D.; Tillmann, W.; Meijer, A.; Hagen, L.
Tribological investigation of surface structures processed by high-feed
milling on HVOF sprayed WC-12Co coatings
- Biermann, D.; Wirtz, A.; Wiederkehr, P.
Design and optimization of energy-efficient milling processes using a geometric physically-based process simulation
- Wirtz, A.; Biermann, D.; T. Siebrecht; Baumann, J.
Disturbance of the Regenerative Effect by Use of Milling
Tools Modified with Asymmetric Dynamic Properties
- Biermann, D.; Huang, N.; Krebs, E.; Baumann, J.; Yuansheng, Z.; Shijing, W.
Experimental investigation on influence of engagement
angle and tool geometry on plunge milling
- Schmidt, R.; Zabel, A.; Strodick, S.; Walther, F.; Biermann, D.
Analysis of the functional properties in the bore sub-surface zone during BTA
deep-hole drilling
- mehr...
-
- Saelzer, J.; Zabel,A.; Biermann, D.
Reibungscharakterisierung und -modellierung in Abhängigkeit der Spanflächentopografie
- Biermann, D.; Zabel, A.; Schmidt, R.; Iovkov, I.
Control of surface integrity in BTA deep hole drilling
- Strodick, S.; Schmidt, R.; Zabel, A.; Biermann, D.; Walther, F.
Evaluation of surface integrity after BTA deep-hole drilling of AISI 4140 by means
of Barkhausen noise analysis
- Baak, N.; Nickel, J.; Starke, P.; Biermann, D.; Walther, F.
Qualification of an inner surface Barkhausen noise sensor for residual stress
measurements of single-lip deep drilled AISI 4140 by means of X-ray diffraction
ICBM13
- Nickel, J.; Baak, N.; Walther, F.; Biermann, D.
Influence of the feed rate in the single-lip deep hole drilling process on the
surface integrity of steel components.
- mehr...
